Note: To add new features, edit geometry or perform analysis, layer has to be imported into the database.

Adding new features

  1. Select a database layer from the Layer List.
  2. Select the Add feature from the ribbon (on the Feature tab).
  3. Select Snapping and/or Measuring option (optional).
  4. Click on the map to add new feature.
  5. When done editing press Enter on your keyboard or:
    • End line by clicking in the last added point.
    • End polygon by clicking on the first polygon point.
  6. Enter attributes in the feature table form and choose Save.

Note: to cancel adding features press Esc key on your keyboard.

NMT_Adding_feature

Note: You can draw a rectangle by selecting a polygon database layer and holding Ctrl button on your keyboard.

Editing geometry

The layer can be modified by using edit tools.

Features in the layer can be edited by following these steps:

  1. Select a database layer from the Layer List.
  2. Select the Edit feature from the ribbon (on the Feature tab).
  3. Select the feature which geometry you wish to edit and move the vertices to the desired location.
  4. Choose Save to save a new point location or Cancel to undo editing.

Note: to perform higher accuracy select Snapping option.

NMT_Feature_Editing1

 

It is also possible to edit feature geometry through the Info Panel:

  1. Select a feature.
  2. From the Info Panel choose Edit Geometry.
  3. Change a location of the feature.
  4. Click Save button.

NMT_Feature_Editing_Geometry